STANDARD TENSILE LINKS

Click here for PDF to print

Manufactured in a range of capacities from 2 tonnes to 25 tonnes utilising high strength, low weight
Duralloy, with grey chromic anodised finish. The links accept standard alloy steel shackles (U.S. Federal
specification RR-C-271D e.g. Crosby, Green Pin). High quality 'Micromeasurements' strain gauges are used
throughout the range; resin bonded to the inner faces under controlled laboratory conditions and sealed.
The high-density nylon cover plates facilitate protection against water and dust ingress to IP65. Throughout
the range, accuracies of better than 0.5% FSD is guaranteed.

SELF INDICATING LINK SWL The large (15mm) display is mounted on the face of the link together with all functions on membrane keypad. The rechargeable battery pack is enclosed within the link. OPTIONS Plug in remote display (hand held or wall mounted) Robust brief case type carrying case. Manufactured of stainless steel, P20 High Grade Steel or EN24T to order.

SELF INDICATING LINK SWLD

FEATURES

Microprocessor based digital electronics.
Liquid crystal display(visible at 6 metres).
V Push button: on/off/zero and tare through membrane keypad.
Low battery indication.
Self-diagnostic (diagnoses faults at 'switch on' and classifies fault with error code).
Non corruptible single point calibration.
Powered by Nickel Metal Hydride battery. Up to 16 hours continuous use between charges.
Mains battery charger with plug.
Robust, nylon reinforced charge plug and socket.

REMOTE INDICATING LINK - SWLD

The link itself has no display, battery pack or control buttons. Included within 1 scope of supply is the type
SWLPC(J) display (see Remote Display - SWLPC(J)), which is connected to the link by a cable which carries both the excitation volt and the load cell output signal. Rear socket IP68.

FEATURES Microprocessor based digital electronics. Robust, nylon reinforced combined, supply/signal/charge plug and socket with locking ring SWLPC(J) remote display (separate specification included within this manual). Standard display cable length 10 metres (see options).

OPTIONS

Plug in remote display (hand held or wall mounted) - see SWLPC.(J)
Robust brief case type carrying case.
Manufactured of stainless steel, P20 High Grade Steel or EN24T to order.
Alternative cable lengths available - up to 100 metres.